Standing seam and metal panel roofing, roof repair and full replacement in Almond. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Almond.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Almond homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Almond home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Almond homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
Much less than people expect. Over solid decking with underlayment under it, a Almond metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
A metal roof installed properly on a Almond home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
A typical Almond shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Often, yes. Plenty of the Almond roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Sometimes. If the decking is sound and there is only one layer of shingles, a Almond metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
For most Almond homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Real feedback from homeowners whose roofs we have worked on.
"They found a leak two other roofers could not. Turned out to be the chimney flashing, not the roof at all. Fixed in one afternoon and it has been dry ever since."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
Our crews cover the surrounding area, not only the city limits.